DMX-DRIVE 8 - DD8

DMX/RDM & WFI/ARTNET 16bit low Voltage dimming and DIN rail flexibility for constant voltage LED applications.
(for wireless only applcations see our CD8)

Z

FEATURES

  • DMX/RDM wired control input
  • RDM remote configuration
  • WiFi/ArtNet wireless control input
  • 8 x CV constant voltage LED control outputs
  • 8-bit personality mode (8 channel footprint)
  • 16-bit personality mode (16 channel footprint)
  • Smoothed or non-smoothed personality modes
  • Compact DIN rail format
  • SELV DC supply input
  • DMX IN/THRU connections
  • Screw terminals (pluggable)

ELECTRICAL

  • 24 Volt DC supply input
  • Common anode (+)
  • 8 x controlled cathode (-)
  • 5 Amp per channel load peak (120W)
  • 10 Amp total RMS continuous load (240W)
1

PHYSICAL

  • 70W x 91H x 60D mm (110H with fixing tabs) 
  • 4 DIN rail modules wide 
  • 150 grams product weight 
  • IP20 protection rating 
  • -20° ~+50°C ambient temp 

CONNECTIONS

  • V+ | Supply Input +24 Volts
  • V- | Supply Input 0 Volts (Common)
  • 1- | Channel 1 output
  • 2- | Channel 2 output
  • 3- | Channel 3 output
  • 4- | Channel 4 output
  • 5- | Channel 5 output
  • 6- | Channel 6 output
  • 7- | Channel 7 output
  • 8- | Channel 8 output
  • Note | All V+ are linked internally
  • Note | All V- are linked internally
  • C | DMX common
  • D- |DMX- data
  • D+ | DMX- data
  • Note | The two DMX ports are wired internally in parallel

IMPORTANT

If removing front cover, ensure correct orientation on refitting!

INSTRUCTIONS

  • For professional installation only
  • Use SELV power supplies of 24 Volts DC
  • Ensure power supplies are equiped with short circuit and over current protection
  • Mount in vertical orientation with air vents slots top and bottom
  • Ensure adequate airflow / ventiallation
  • Make all connections before energising
  • Test loads before connection to DD8
  • Use RDM equiped controller/tester to configure DMX start address and personalaties